![Gm 350 software](https://kumkoniak.com/66.jpg)
![gm 350 software gm 350 software](https://static.summitracing.com/global/images/prod/xlarge/hpe-sp04_jw_xl.jpg)
![gm 350 software gm 350 software](https://www.3dcadbrowser.com/ts/2/58/58382.jpg)
Mounting on standard DIN-Rail, with or without Power Bus, in Safe Area or in Zone 2. The module is also provided with PhotoMOS alarm output.Ī modbus output is also provided to interface the PLC/DCS using digital communication. It provides a fully floating power supply voltage with remote sensing capabilities to load cells located in Hazardous Area and converts the mV signal from the load cell into a 0/4-20 mA, providing both current source and sink capabilities. Up to four 350 Ω load cells, or five 450 Ω load cells, or ten 1000 Ω load cells can be connected in parallel. You can find the software as wgm950 on the net. All you need is a different programming software. The setup is pretty much the same I used for the GM950 models. The unit acts as a galvanically isolated interface installed between a PLC/DCS in Safe Area and a load cell (or a group of load cells) in Hazardous Area. Since I am totally into these Motorola devices at the moment I picked up a GM350 and looked into the programming of these devices. The single channel DIN Rail Load Cell/Strain Gauge Bridge Isolating Converter D5264S module is a unit suitable for applications requiring SIL 2 level (according to IEC 61508:2010) in safety related systems for high risk industries. All the operational parameters of the GM350 can be field programmed by an IBM PC or compatible computer, using Motorolas most advanced programming software.
![Gm 350 software](https://kumkoniak.com/66.jpg)